HS code-based compliance checks for EU

List of the contents of this article:

• 1, What to do if the car display suddenly does not display
• 2、What is the reason why the central control display of the car does not light up
• 3, What is the reason for the black screen of the car display?

What should I do if the car display suddenly does not display

1. It is possible that the battery is out of power and there is no fault. In this case, you just need to charge the car. It may be that the display is overloaded, resulting in serious heating, triggering the protection system, and the screen will be black at this time. In this case, you only need to wait for the heat dissipation to be completed, and you can also turn off other electronic devices to help heat dissipation.

2. It can be said that this is basically a host problem. Move the host to a nearby repair shop for repair. Poor contact. The car display does not light up, which is a problem of poor contact. If the car is turned on, it can be turned on normally, which indicates that the current rises immediately, so it is turned on, and then not turned on. The DVD seems to be in poor contact or circuit problems.

3. In fact, when the on-board display is not lit, you can carefully check the port wiring of the navigator to see if the line port will fall off due to the vibration of the vehicle during the driving process, and it can be used by plugging it in. Of course, it is also necessary to check the stability of the power supply voltage of the car to rule out the possibility of unstable voltage.

4. The reason why the display is not displayed in the car and the solution: 1. If DVD is stuck during operation, and then the display on the car does not light up, and the touch does not respond. The power supply of the display on the car is restarted; the third-party software does not match the system. Check whether you have downloaded new software recently.

5. The display of the car does not light up, there may be the following reasons: Power supply problem: Check whether the car battery is normal and whether it is charged. If the battery is dead, it needs to be charged first. Fuse problem: Check whether the fuse on the display is burned out. If so, a new fuse needs to be replaced.

6. It is necessary to disassemble the central control vehicle system of the motor vehicle, and only by checking the specific problem can it be effectively solved. There are many reasons why the on-board screen suddenly cannot be displayed: the vehicle's computer system is damaged. The power supply of the vehicle-computer system was cut off.The Fuse Of The Car System Has Melted.

What is the reason why the central control display of the car does not light up

There are many reasons: there is a problem with the power supply of the central control system; the central control screen is damaged; the insurance of the central control system is damaged. The above problems will cause the central control screen not to light up, and the central control screen system needs to be disassembled. After the disassembly is completed, the central control display can be repaired and used normally.

The reason for the black screen of the car display is that the power supply voltage of the car is unstable. There is something wrong with the cable on the back of the central control display. The solution to the black screen of the car display is to check whether the host power supply is well plugged in and whether the voltage is stable. Check whether the data cable connector of the monitor is in good contact with the signal output interface of the graphics card.

There are two reasons for the black screen of the central control display of the car: the power supply voltage of the car is unstable;There is a problem with the cable on the back of the central control display. The central control of the car is the place where the car air conditioner, audio and other comfortable entertainment devices are controlled.

First, check whether the power supply of the display is normal. If the power supply is not normal, please replace the power supply module. Then check whether the wiring contact is good. If there is a problem, replace the wiring. Check whether the display is damaged and replace the display for testing. If it returns to normal, the display is damaged.

There are many reasons why the central control screen of the car does not light up, such as: aging power signal line, poor line contact, power supply module failure, owner's misoperation, the reason for the display itself, etc. If the power signal cable is aging, it will cause the central control screen not to light up. The solution is to replace the new signal cable, which can be solved.

What is the reason for the black screen of the on-board display

The reason for the black screen of the on-board display may be caused by the lack of power of power of the navigator; the line port is loose or falling off; the power supply voltage of the car is unstable; or the on-board system is dead. You can restart it to see if it can be solved. If not, you can go to the repair shop for further inspection and maintenance.

Causes for the black screen of the car display: the power supply voltage of the car is unstable; the cable on the back of the central control display is abnormal; the computer accessories are of poor quality or damaged; the connection between the memory graphics card and the motherboard is wrong or loose, resulting in poor contact; excessive overclocking or overclocking of parts that cannot be overclocked .

The reasons for the black screen of the vehicle screen are caused by the overheating of the central control screen, the virtual connection of the power supply system or the iron line, the defects of the server software parameters, and the failure of the hard disk of the central control screen itself.What's wrong with the black screen of the car? Because the central control screen is overheating, it is generally caused by the installation of other additional machines and equipment, such as navigation modules, reversing rearview, etc.

There are many factors that cause the black screen of the on-board display, which may be due to power wiring problems or line failure. In case of black screen, you can try to restore the on-board navigation to factory settings or use the computer to troubleshoot.

The power supply module failed. This kind of failure is generally rare, but once the power supply module fails, it will cause the display screen to be stuck or even directly black. The power supply module can be replaced to solve the problem. The power signal line is seriously aging. It will also cause the black screen of the car display. Just replace the new power signal cable and it can be solved.

The black screen of car navigation may be caused by the unstable voltage of the car power supply.If the voltage is stable, check whether there is a problem with the cable on the back of the machine and replace the connection for testing. If there is only an image without sound, it means that the power plug-in of the navigation monitor is loose; if there is no sound or image directly, the DVD should be broken.