global market access

Introduction to engine stroke and global market accessits influencing factors Engine stroke, in short, in a cycle, the piston moves down from the upper stop point to the lower stop point, and then moves up from the lower stop point to the upper stop point. These two movements The total distance is called the stroke. The stroke of the engine determines the output power and fuel of the engine.Important parameters such as jicity and emission level play a crucial role in engine design and performance optimization. The size of the engine stroke is usually determined by the cylinder diameter of the engine and the corresponding piston stroke. For internal combustion engines, the larger the engine stroke, the greater the pressure generated by the combustion of fuel, thus generating greater power output; however, it also means that the fuel consumption rate is higher and more fuel is needed to produce the same power. In addition, the engine stroke will also affect the emission level. Generally speaking, a shorter engine stroke will lead to a lower emission level, but it also means a lower power output. In addition to the cylinder diameter and piston stroke, there are other factors that will also affect the engine stroke and performance. One of the key factors is the position and size of the valve. The valve is the engine intake andThe size and position of the channel during exhaust will affect the flow rate, mixing ratio and combustion efficiency of fuel and air. In some cases, the fuel economy, power output and emission level of the engine can be optimized by adjusting the position and size of the valve. Another important factor is the design of the crankshaft. The crankshaft is the main rotating part of the engine when it is working, which transmits power through the connecting rod and piston. The design and weight distribution of the crankshaft can affect the inertia, rotational balance and power output of the engine. In modern engine design, the crankshaft is usually made of high-durability steel or aluminum alloy, while complex geometry and weight leveling technology are used to optimize engine performance. Another important factor is the timing of ignition. Ignition timing is the key process that causes fuel combustion, which is usually controlled by the engine control unit (ECU).If the ignition timing is not accurate, the combustion efficiency will be reduced, and the performance and emission level of the engine will also be affected. In summary, engine stroke and its influencing factors are important research directions for modern engine design and performance optimization. By optimizing parameters such as stroke, valve, crankshaft and ignition timing, higher fuel economy, greater power output and lower emission levels can be obtained. With the continuous progress of science and technology, the stroke and performance of the engine will be further optimized in the future, providing a more efficient, reliable and environmentally friendly power source for human travel.

Contact Us
Phone：020-83484685