Global trade barrier analysis

How to disassemble the engine and Global trade barrier analysismaintain the engine of the vehicle is the heart of the whole car, and its operating status directly affects the performance and life of the whole vehicle. Therefore, during the use of the vehicle, the engine must be maintained regularly. Disassembly of the engine is an important way to carry out thorough maintenance and overhaul. This article will introduce the steps and precautions for disassembling the engine.Preparations before disassembly. Before disassembly of the engine, some preparations are needed to ensure the smooth disassembly and maintenance process. First of all, it is necessary to comprehensively test the engine with professional tools to understand the faults and handling methods of the engine. Secondly, it is necessary to prepare the necessary tools and equipment, such as wrenches, pliers, compressors, airtight leak detectors, scales, etc. Finally, the place where the engine is disassembled must be well ventilated and there is enough working space. Step 1 of disassembling the engine. To remove external parts, first of all, it is necessary to remove the external parts of the engine, such as intake pipe, exhaust pipe, wire, etc., and put them aside. It is necessary to note that the location should be clearly marked when storing, so that it is easier to install during assembly. Two. After removing the engine head, you need to remove the engine head, including the valve cover, camshaft, valve, spring, duct, etc.This requires skills and experience, the use of the right tools and equipment, and always pay attention to prevent collisions and wear of parts. 3. Disassembly of the engine cylinder block Disassembly of the cylinder block is the most important and complex link. When disassembly, it is necessary to pay attention to the size and quantity of each loose or removed part for easier assembly later. Usually, it is necessary to disassemble the piston ring, connecting rod, crankshaft, oil pump, oil pipe, intake manifold, etc. At the same time, it is necessary to carefully clean the cylinder block in order to better check the details. Four. After cleaning and checking the engine parts, each part needs to be carefully cleaned and checked. Chemical cleaning liquid and brushes can be used to clean engine parts to thoroughly remove old oil, dust, residue and mud. Checking the engine is also very important, and it is necessary to carefully inspect the cracks, wear and damage of each part.If a problem is found, it should be repaired and replaced appropriately. 5. The assembly process of the engine is just the other way around. You need to pay attention to the installation order and quantity of each part, and pay attention to the general use of lubricant and the placement of free bullets to avoid errors. Precautions: 1. When disassembling and maintaining the engine, you must be careful, careful and cautious to ensure that no secondary damage will be caused; 2. When disassembling the engine, the parts should be put in a clean box and petrochemical bag to prevent the loss of dust and small parts; 3. When remoting and tightening parts, each part should be correctly marked according to relevant regulations and reference books to avoid confusion; 4. When disassembling electrical components, you should pay attention to disconnect the power supply and power cord to prevent short circuit damage to other equipment; 5. When inspecting and maintaining the engine, you must use professional tools and equipment to ensure that the results are accurate and reliable;6. When disassembling the engine, it needs to be thoroughly cleaned for better inspection and repair. In a word, disassembling the engine requires certain skills and experience, and requires careful preparation and maintenance. If you are not sure whether you have such a skill, you need to seek the help of experts and mechanics. I hope this article can be helpful to your maintenance work.

Contact Us
Phone：020-83484685