FMCG sector HS code analysis

List of the catalog of this article:

• 1,What is the reason for the engine power reduction, what is the reason for the engine power failure
• 2, What causes the lack of engine power?
• 3, What's the problem with weak acceleration of the engine?
• 4, What is the reason for the weak acceleration of the car engine?
• 5、 Engine shake, weak acceleration, jerk

What is the reason for the engine power reduction, startWhat is the reason for the weakness of the machine?

1. If the air intake system is blocked or leaks, it will inevitably affect the inflation efficiency of the engine, resulting in a decrease in engine power and acceleration performance. Specifically, the air filter, air intake pipe and various vacuum hoses should be checked for blockage or leakage. Check whether the exhaust system is blocked.

2. The reason for the fuel supply system: Due to the blockage of the ventilation hole of the fuel tank cover, the fuel tank switch, the fuel filter and the oil pipe between the fuel tank and the carburetor are partially blocked, which cannot meet the supply of the required amount of oil, resulting in the mixture gas being too thin and the engine is weak.

3. Poor engine maintenance; poor quality of fuel and oil; insufficient combustion of mixed gas; spark plug failure, ignition coil failure; fuel pump failure, oil line blockage; air conditioning filter blockage, caused by mechanical failure of the engine itself.

4. Reasons for insufficient power of the car: the fuel pressure is too low, the ignition attendant is not broken, the cylinder pressure is insufficient, etc. The fuel pressure is too low, resulting in insufficient oil supply and insufficient power. Solution: It is recommended to clean the fuel injector and check the oil pressure at the same time.

5. If the engine assembly is too tight and the oil is too thick, it will cause excessive engine resistance. In addition to overcoming its own friction and the resistance of the auxiliary device, the effective power output produced by the engine is reduced, that is, the engine is weak. Next, let's learn about the principle of engine power: material power.

What causes the lack of engine power?

1. If the orifice diameter of the fuel injector changes due to carbon blockage or wear, the actual injection volume of the fuel injector will decrease under the condition that the pressure of the fuel system and the injection pulse width remain unchanged, resulting in insufficient engine power. In addition, if the fuel injection atomization is not good, it will affect the combustion quality of the mixed gas, resulting in insufficient engine power or poor acceleration.

2. Do you know all these reasons? Grab the first like, comment, share, report, Jiangxi Wantong Automobile Training College 2023-12-11· Jiangxi Automobile New Energy and Intelligent Network Skills Training Institute pays attention to the dirty air filter element, which will also lead to insufficient engine power. At this time, it will obviously feel that the acceleration cannot be raised.

3. It is often manifested in the blockage of the fuel filter and the increase of the oil resistance, which makes the fuel injection pump supply insufficient. The filter should be cleaned and replaced regularly in accordance with the instructions for use. The fuel tank is too dirty, and the partial blockage of the oil-absorbing pipeline is also a common reason for insufficient power. Oil supply system leakage: This kind of failure often occurs after maintenance.

What's the problem with weak acceleration of the engine?

What is the problem with weak acceleration of the engine? Serious carbon accumulation: When the car is driving at low speed for a long time, it is easy to produce carbon accumulation and block the oil system, thus causing the symptoms of weak acceleration.Poor quality of oil: The poor quality of the oil used will affect the gasoline filter and oil line, which may lead to poor oil supply, resulting in weak acceleration.

The specific analysis is as follows; sensor problem; the sensors mentioned here include water temperature, crankshaft position, air flow, intake temperature, oxygen sensor, etc. When these sensors are damaged, poor contact or the signal is interrupted, the ECU of the car cannot accurately obtain the engine data, and at this time it will Cause the engine fault light to turn on.

The reasons for the weak acceleration of cars are as follows: Carbon accumulation: There are three reasons for the weak acceleration of cars. First of all, the valve, idling motor, air intake, combustion chamber and spark plug are carbonized, so there will be a ceasefire when the car is idling.

What is the reason for the weak acceleration of the car engine?

1. There may be many reasons for the weak acceleration of cars, such as engine carbon accumulation, urban road conditions, refueling conditions, etc. The detailed reasons are as follows: caused by carbon accumulation.

2. It may be the phenomenon of carbon accumulation. When there is too much carbon accumulation in the engine, the ignition energy of the car will be greatly reduced, and the air intake efficiency will also continue to decline. There will be a decrease in engine power, and then there will be a weak acceleration. It may also be that there is a problem with the car's fuel system.

3. What is the problem with weak acceleration of the engine? Serious carbon accumulation: When the car is driving at low speed for a long time, it is easy to produce carbon accumulation and block the oil system, thus causing the symptoms of weak acceleration. Poor quality of oil: The poor quality of the oil used will affect the gasoline filter and oil line, which may lead to poor oil supply, resulting in weak acceleration.

4. The reasons for slow acceleration and weak acceleration of the car are: the failure of the engine's oil line system; the failure of the engine's intake system; spark plugs are also the source of common faults; engine cylinder problems; insufficient tire pressure; the engine is too busy when the air conditioner is turned on in summer. The abnormality of the fuel system leads to too low pressure.

5. Locomotive tycoon ar 2023-12-05 · Contributed more than 396 answers. Attention: Engine shaking, weak acceleration, and jerky may be caused by the failure of the fuel system, ignition system or engine mechanical parts. It is recommended to send the vehicle to a professional repair station as soon as possible. Inspection and maintenance.

6. Reasons for the weak acceleration of the car: the engine accumulates too much carbon, resulting in poor fuel atomization; there is a problem with the air flowmeter, causing the mixed gas to be too thick or too thin, affecting the acceleration function;The failure of the ternary catalyst or turbocharger; the failure of the spark plug, affecting the acceleration function, etc.

Engine shaking, weak acceleration, jerking

1. Engine shaking, weak acceleration, jerky may be caused by the failure of the fuel system, ignition system or engine mechanical parts. It is recommended to The vehicle was sent to a professional repair station for inspection and maintenance.

2. The engine accumulates carbon. Carbon accumulation, as an intractable disease of the engine, is an important reason for car failure. Whether it is the carbon accumulation in the fuel nozzle, throttle valve, air intake, combustion chamber and other parts, it will cause car failure. Therefore, it is necessary to regularly use effective PNF original liquid fuel additives to clean oil lines and accumulate carbon.

3. Engine shaking, acceleration, weak acceleration and a sense of stuttering are generally caused by lack of cylinders. The lack of cylinder is very likely to be caused by the failure of the ignition system; lack of cylinder refers to the fact that one of the cylinders of the engine does not run; the lack of cylinders will cause the smoothness of the engine to decline and the driving force to be insufficient.

4. This situation may be caused by the lack of cylinder, which is likely to be caused by the failure of the ignition system. Lack of cylinder means that the cylinder of the engine does not work, resulting in a decrease in the stability of the engine and insufficient power. The main components of the ignition system include ignition coils and spark plugs.